N2-conditioning:
N2 required to provide external, flow rate can be fine-tuned
nitrogen tolerance, back to welding to reduce the oxidation
process for unleaded and leaded Process, adjusting the scope of
0 ~ 25 M3/min (1 LPM = 28 1/min).
ammeter: shows
the current use of current, start heating current 15A, Tatsu set
temperature, temperature compensation at about 6.2A ~
8A.
hours on this
machine under the heating zone and heating zone, equipped with
two sets of temperature controller can be configured to control,
respectively independent with different heating
temperature.
and normal by
the start the heat engine to reach set temperature at a cost of
about 25 minutes.
Thermostat
function:
advanced 2-DOF PID temperature control, together with
FUZZY-order functions manually adjusted.
Microcomputer PID temperature control, micro-computer
automatically adjusts the heating time and the curve
width can be self-heating temperature.
ntelligent temperature control, monitoring changes in
the working environment,self-RUN self-tune PID values,
stability requirements set temperature,
Temperature regulation +0.5% FS +1 igit.
Temperature setting range: 28 ℃ ~ 420 ℃
Temperature Display Accuracy: 0.1 ℃.
timer function -
can demand back into the welding zone set time, set the range
of 0.1~ 999se set accuracy 0.1sec, the time. By the operator to
change settings at any time free
time
AUT0-automatic
key, pallet conveyor automatic BGAIC to reflow zones, track the
implementation of set the time line back to welding, completed
disk Orlando Automatically exit, return to the starting area,
the cooling fan to complete the reflow
process.
shutdown on the
eve of the closure to be welded to their back button to return
to welding temperature to be cooled down to below 100 ℃ in order
to close the electric POWER Source button, and after the closure
of the total power valve.
take home tray
operation, do not the weight tray, causing the sliding axis
bending deformation, resulting in the road when the tray is not
smooth.
TU-380